Published News

radon fan installation 11

https://myradonretestblog.urbanvellum.com/posts/why-a-radon-retest-matters-for-your-jefferson-county-home

When I finally decided to install a radon mitigation system, the fan placement turned out to be the trickiest part. You can't just stick it anywhere—it needs to be in the attic or outside the living space, properly venting through the roof or sidewall. The electrician had to run a dedicated circuit because those fans pull constant power. I remember watching him seal every joint with foil tape and mastic, making sure no exhaust could seep back indoors. It took a full day, but now the continuous…

radon mitigation st louis 4

https://radoncontractorstlouiszone.urbanvellum.com/posts/why-you-need-a-radon-contractor-st-louis-homeowners-trust

Radon mitigation in St. Louis is important because the area's geology, especially the underlying limestone and shale, allows the gas to seep into homes. Many older houses with basements or crawl spaces need a system to pull the gas from under the foundation and vent it safely outside. A local contractor will usually install a sub-slab depressurization setup, which involves sealing cracks, running a pipe through a floor drain or a cleanout, and adding a fan to create negative pressure. It's a st…

EPA radon action level 4

https://radontestcostscope.urbanvellum.com/posts/understanding-radon-test-cost-for-st.-louis-homes

The EPA radon action level is set at 4 picocuries per liter of air, meaning if your home tests at or above this amount, the agency strongly recommends taking steps to reduce radon levels. It's not a legal requirement but a health-based guideline, since prolonged exposure to high radon is linked to lung cancer. Many people test their basements or ground-floor living spaces, then install mitigation systems like sub-slab depressurization to bring levels down.